| T O P I C R E V I E W |
| stevewildcat1 |
Posted - 26 Nov 2011 : 20:52:22
Hi Gang
Need to replace both my throttle cable and also the gear cable to enfield zdrive. have never seen inside of remote, am sure i can just replace inner of throttle cable, looks just like brake cable engine end. not got a clue about gear cable. any help would be good. how easy are they to change and set up?
Steve
Little Lottie, Thorne |
| 5 L A T E S T R E P L I E S (Newest First) |
| stevewildcat1 |
Posted - 27 Nov 2011 : 20:36:09
cheers guys.
will have to get down to boat again b4 winter creeps in to check cable length. then learn something else i didn't know about. thanks for the pointers guys
Steve
Little Lottie, Thorne |
| df |
Posted - 27 Nov 2011 : 18:49:42
The remote should do the 'gear before throttle' bit for you, the rest is just making sure the neutral position is well centred on the outdrive gear lever, it will probably be a 33c cable avaible in most lengths with 3/16" unf end threads which take most fittings.
NBAS--The communal colostomy bag of the boating community.
Visit leomagill.co.uk |
| Lester Mayo |
Posted - 27 Nov 2011 : 15:35:28
If you get the exact cable (ends not total length of cable) then you can count how many turns the end fitting takes to come off, this will let you have to make minor adjustments only.
You need to have the gear throw completely into gear, then when you move the lever a little more the throttle cable will start to engage.
You can check the full engagement forward and reverse at the lever arm on the leg. Then I would connect the throttle cable which is easier. |
| stevewildcat1 |
Posted - 27 Nov 2011 : 12:33:05
thanks Lester, is there a method to setting it up or is it just hit and miss?
Steve
Little Lottie, Thorne |
| Lester Mayo |
Posted - 26 Nov 2011 : 21:02:28
Steve you have to replace the whole cable inner and outer as they are a sealed unit. In the remote its easy to remove the cable hat is important is setting it up for the throw into gear before the throttle kicks in.
There should be a size written on the outer cable ends. I would tape the new cable to the old and pull it through if possible. |
