All Forums

Norman Boats

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:

UserName:

Password:

Format Mode:

Format:

Message:

* HTML is OFF
* Forum Code is ON

Click here to attach a photo to your post

Check here to include your profile signature.

T O P I C R E V I E W
Stan the Man	Posted - 18 Oct 2011 : 07:40:17 I suspect most of the Normans built around the late 70s/early 80s were fitted out with the same formica finish on the bulkheads/cupboard carcases, etc. I do seem to remember this as Teak from my memories of that era, but this is now pretty rare and new edging, whilst still available, requires more than just a trip down the local DIY. So that I do not end up with a 50 metre coil of the wrong colour, I would be most grateful if anyone knows whether it is Teak or not. Thanks in anticipation.
3 L A T E S T R E P L I E S (Newest First)
Knighty	Posted - 19 Oct 2011 : 21:34:15 Some of my edging was split or missing, i ordered the iron on teak veneer edging from eBay where you can order small amounts if you search. I ended up gluing it on and where it needed it i stripped the whole edges off and a light sand before gluing on and with a couple of coats of satin varnish didn't look too bad.
Stan the Man	Posted - 19 Oct 2011 : 07:01:34 Lester Mayo All the doors, bulkheads and internal walls are indeed finished in formica with the "real" wood reserved for cabinet shelves and backs and the various trims. I'll take a photo today and post it on the offchance that anyone recognises the finish. Regards, Stan Owen
Lester Mayo	Posted - 18 Oct 2011 : 18:10:29 Formica? The wood finish was sapele still prety much available as timber but scarce in ext plywood form above 12mm.